Page 1 A. NOTICE 1. This information is believed to be reliable; however, we assume no responsibility for inaccuracies or omissions. Th
Page 2 4. Incorrect battery voltage or incorrect wire connection may damage the wind turbine, and these are not covered by the
Page 3 3. Make sure a minimum 50 cm clearance is provided between the blade tips and any obstructions. Refer to Figure 2. 4. Mark and centre-pu
Page 4 CAUTION: If you are uncertain of the polarity of the wires, simply spin the rotor shaft clockwise and measure the voltage direction with
Page 5 3. Put the M16 nut onto the middle of the Hub, then put the Hub on the top of the rotor shaft. Hold on the rotor shaft with a screw drive
Page 6 G. Specification H. Additional Information 1. How the embedded controller works: a. The embedded PWM controller is mounted inside t
Page 7 can easily exceed 12V. 4. Connect the turbine to the battery directly with an ampere meter, spin the turbine by han
Page 8 Warranty Repairs All returns must have a valid RMA number written clearly on the outside of the box. Without an RMA number the ship
Comments to this Manuals